PM09 Engine base for CR500 (pre-order)

$3,800.00 USD$4,200.00 USD

EAN: N/A SKU: N/A Categories: ,

Description

This complete engine block is the bottom end part of the Panthera PM09 600CC engine. It is made to endure the extreme power of our Panthera cylinder and will make a bullet proof base for your CR500. This engine is complete and fully assembled.

THIS ENGINE BASE HAS THE CHASSIS BOLT PATTERN OF A CR500 AND THE CYLINDER BOLT PATTERN OF THE CR500.

ENGINE BALANCER SHAFT

It will grant you the addition of a COUNTER BALANCER SHAFT and ELECTRIC STARTER for your CR500.

THIS ENGINE BASE HAS OVER 70% LESS VIBRATION THAN THE CR500 !

CLUTCH

The engine comes with our high capacity clutch with 80% more torque capacity than the OEM clutch from honda. The actuator offered are :
-hydraulic slave
-cable actuator.

TRANSMISSION

The primary ration of the engine base has been increased to 2.25 to reduce loads on both clutch and transmission. You will also be able to run a smaller front sprocket
Two transmission ratio are offered:
Standard ratio – 1.75 / 1.39 / 1.15 / 0.95 / 0.79
HRC ratio – 1.75 / 1.39 / 1.09 / 0.87 / 0.72

CRANKSHAFT

We offer two possibility of crankshaft stroke :
– 79 mm
– 84.5 mm

WATERPUMP

The engine cases are equipped with a water pump with 70% higher flow capacity compared to oem, making the cooling of your engine more efficient.

Additional information

Weight 10 lbs
Dimensions 24 × 20 × 16 in
Crankshaft stroke

79mm, 84mm

Transmission

2001 CR500 ratio, HRC long ratio

Clutch actuation

Hydraulic clutch, Cable clutch

Electric starter

Electric starter, No electric starter